ETON | Home Use Round Classic Electric Waffle Maker
Basic parameters of products
Round Classic Waffle Maker
Restaurant , Home , Snack shop and etc
The use of notes:
1, the supply voltage must match the rated voltage.
2, three-prong outlet is installed near the equipment with a well-grounded.
3, the device temperature was adjusted at 250 ºC ± 5%.
4, the device has a time-setting, only time prompts, and electrical properties of the device is not linked.
Instructions for use:
1, plug in the power outlet, press the power switch, indicator lights, rotate the thermostat knob to set the desired temperature, the device begins to heat, when the temperature reaches the set temperature, the machine can automatically stop heating, when the temperature is low at the set temperature, can automatically power, heated again, so the cycle of work, to keep the temperature constant within a set range.
2, the maximum temperature for about 15 minutes from the time required to press the power switch until the furnace temperature reached 300 ºC.
3, after the device temperature reaches 250 ºC, the first light in the mold coated edible vegetable oil, then make a slurry within the template upside down, cover the lid, adjust the settings on the right time (time setting range 0 ~ 5 minutes, set the time at the discretion of the operator). When the time reaches the set time, the furnace issued a "ding" sound sound, prompts the operator, production time has come to make complete. You can make the next food. When the food all the production is completed, the power should be cut off.
4, may be interested in from the set time based on food color paste formulation different and customers
Line set, in general, the longer the deeper the color, whereas the more light color, but not too short, otherwise unfamiliar food, no color, and unsanitary.
5, the cleaning of the equipment: This device can be used with wet towels cleaning solution for cleaning,
But we can not use water to clean, but not soaked in water to clean, or easy to damage the electrical performance of the machine, prone to accidents electricity.
General failure to check:
Power on, press the switch, indicator light, set the temperature, but not heat
1. Thermostat damage.
2. There is a heating pipe blown.
1. Replace the thermostat.
2. Replace blown electric tube (heating pipe has two, each 110-volt, 220-volt series use)
Power on, press the switch, indicator light, temperature rise can not be controlled.
Replace the thermostat
Power on, heating properly, but the indicator does not light
Power on, press the switch, the indicator does not reveal their unheated
Power is not normal, no power, or blown fuse
Check the power supply is normal or replace the fuse so