Fully Automatic Stainless Steel Cup Sealing Machine (ET-Q9)
Size 300*360*535mm
Power Supply 220V/50Hz
Power 360W
Out Put 300~400cup/h
Products with highest performance-price ratio.
Auto detecting, auto film rolling and auto sealing
Easy to operate.
with the designed lifespan of 100, 000 cups, after 120, 000 cups' sealing, the quality is still good.
Our cup manual sealer are foumas at home and in Indonesia, Vietman, Thailand. Maunal cup sealer is considered as best quality among Chinese suppliers.
Elegant shape.
Personalized design, easy to operate.
Strict quality control, quality parts.
The film material and sealing temperature:
PE (Polyethylene):170 °C
PP (Polypropylene):170 °C -200 °C
PS (Polystyrene):180 °C
Film: 120 °C-180°C
PET (Polyester): 160°C -200°C
Sealing procedures (panel operating instructions):
1. Power, turn the power switch, indicator lights, the thermostat is set to a predetermined temperature, when the green heating indicator light. When the hot plate reaches a predetermined temperature, the red indicator light is constant (sealing machine at work, electric heating and insulation means constantly alternating states, so green and red lights are constantly alternating, this is normal).
2. The plastic cups were placed in the lower mold slide, slide his hands pushed into the die to determine the location, after touching the limit switch, the module automatically after receiving the signal under the pressure seal, reset automatically rise, touched on travel switch on mold motor stops. film motor begins to turn, turned a predetermined length film by electric eye controlling the motor stops automatically.
3. After the film must be the motor rotation, only pulled lower mold slide the plastic cup into the lower mold slide pushed into the next cycle begins.
Precautions:
1, take a good ground to ensure safe use of electricity.
2, when the machine fails, you should turn off the power, resume normal temperature before troubleshooting.
3, the use of the process must not hand into the upper and lower mold, so as not to crush or burns.
4, carrying cup push die movement, the die must be carried out at the highest point of stop motion.
5, template-carrying cup to a later innermost allowed rebound, or upper and lower mold will be damaged.
6, the working voltage must be maintained at 220V ± 5%.
){kind=link}